Job Prints From The Wrong Tray Or On The Wrong Paper; Incorrect Characters Print; Tray Linking Does Not Work - Lexmark C736 series User Manual

Troubleshooting
C P P
HANGE THE AGE ROTECT SETTING TO
1
From the printer control panel, press
2
Press the up or down arrow button until
3
Press the up or down arrow button until
4
Press the up or down arrow button until
5
Press the up or down arrow button until
6
Press the up or down arrow button until

Job prints from the wrong tray or on the wrong paper

C
HECK THE PAPER TYPE SETTING
Make sure the paper type setting matches the paper loaded in the tray:
1
From the printer control panel Paper menu, check the Paper Type setting.
2
Before sending the job to print, specify the correct type setting:
•
For Windows users, specify the type from Print Properties.
•
For Macintosh users, specify the type from the Print dialog.

Incorrect characters print

M
AKE SURE THE PRINTER IS NOT IN
If Ready Hex appears on the display, then you must exit Hex Trace mode before you can print your job. Turn the
printer off and back on to exit Hex Trace mode.

Tray linking does not work

These are possible solutions. Try one or more of the following:
L
OAD THE SAME SIZE AND TYPE OF PAPER
•
Load the same size and type of paper in each tray to be linked.
• Move the paper guides to the correct positions for the paper size loaded in each tray.
U P
SE THE SAME APER
•
Print a menu settings page and compare the settings for each tray.
• If necessary, adjust the settings from the Paper Size/Type menu.
Note: The standard 550-sheet tray and the multipurpose feeder do not automatically sense the paper size. You
must set the size from the Paper Size/Type menu.
O
FF
.
H T
EX RACE MODE
S P T
IZE AND APER YPE SETTINGS
Settings appears, and then press
General Settings appears, and then press
Print Recovery appears, and then press
Page Protect appears, and then press
Off appears, and then press
.
.
.
.
.
172