Table of Contents
Advertisement
S
S
UPER
ERVER 6026T-3RF User's Manual
Figure 6-1. Front and Rear Chassis Views
3.5" Drive Bays (2)
Slim DVD-ROM Drive
SATA Drives (8)
Keyboard/Mouse Ports
USB Ports
6-2
Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the serverboard to the Control Panel PCB (printed circuit
board). Make sure the red wire plugs into pin 1 on both connectors. Pull all excess
cabling out of the airfl ow path. The LEDs inform you of system status.
See Chapter 3 for details on the LEDs and the control panel buttons. Details on
JF1 can be found in Chapter 5.
USB Ports (2), COM Port
Floppy Drive (optional)
IPMI LAN
COM1 Port
VGA Port
6-2
System Reset
Main Power
7 Low-Profi le PCI Slots
Ethernet Ports
Control Panel
Advertisement
Table of Contents
