Table of Contents
Advertisement
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is on
pins 1 and 2 to enable VGA. See the
table on the right for jumper settings.
LAN1/2 Enable/Disable
Change the setting of jumper JPL1
to enable or disable the JLAN1 and
JLAN2 sets of Ethernet ports on the
serverboard. See the table on the right
for jumper settings. The default setting
is enabled.
2
I
C Bus to PCI-X/PCI-Exp. Slots
2
2
Jumpers JI
C1 and JI
connect the System Management Bus
2
(I
C) to the PCI-Express slots. The
default setting is Open (Disabled.) Both
jumpers must be set to the same setting
See the table on the right for jumper
settings.
TPM Support Enable
JPT1 allows the user to enable TPM
(Trusted Platform Modules) support
to enhance data integrity and system
security. See the table on the right for
jumper settings. The default setting is
enabled.
Chapter 5: Advanced Serverboard Setup
C2 allow you to
Jumper Setting
2
JI
JI
2
5-21
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting
Defi nition
Pins 1-2
Enabled
Pins 2-3
Disabled
JLAN1/2 Enable/Disable
Jumper Settings (JPL1/JPL2)
Jumper Setting
Defi nition
Pins 1-2
Enabled
Pins 2-3
Disabled
2
I
C to PCI-X/PCI-E Slots
Jumper Settings (J12/J13)
Defi nition
2
C1: Closed
JI
C2:Closed
C1: Open
JI
2
C2: Open
TPM Support Enable
Jumper Settings
Jumper Setting
Defi nition
1-2
Enabled
2-3
Disabled
Enabled
Disabled
Advertisement
Table of Contents
