Installing The Heatsink - Supero SUPERSERVER 6026T-3RF User Manual

Installing the Heatsink

1. Place the heatsink on top of the
CPU so that the four mounting
holes are aligned with those on the
retention mechanism.
2. Remove the thin layer of protective
fi lm from the copper core of the
heatsink.
Warning: The CPU may over-
! heat if the protective fi lm is not
removed from the heatsink.
3. Apply the proper amount of ther-
mal grease on the CPU. If your
heatsink came with a thermal pad,
please ignore this step.
4. Screw in two diagonal screws (i.e.
the #1 and the #2 screws) until
just snug (do not over-tighten the
screws, which may damage the
CPU.)
5. Finish the installation by fully tight-
ening all four screws.
Chapter 5: Advanced Serverboard Setup
Thermal Grease
CPU
Note: The 6026T-3RF uses passive
heatsinks.
5-7