Switch Housing And End Cap Installation - Casablanca C19xxxK Owner's Manual

SWITCH HOUSING AND END CAP INSTALLATION

SWITCH HOUSING HARDWARE (not to scale)
Switch Housing
Phillips
Cap Plug
Screwdriver
Switch Housing Installation
Step 12a. Place the switch housing gasket against
the adapter plate and partially install two of the three
switch housing screws onto the switch housing
adapter plate as shown in Figure #1.
Step 12b. Thread the Molex Plug through the hole
in the center of the switch housing and align the two
keyholes with the two screws that were installed on
the switch housing adapter plate. Place the switch
housing over the two screws and rotate it clockwise
so that the two screws are holding the switch housing
as shown in Figures #2 and #3.
Step 12c. Align the screw hole on the switch housing
with the screw hole in the switch housing plate and
insert the third screw as shown in Figure #3. Then
tighten all three screws with the provided screwdriver.
SWITCH
HOUSING
GASKET
SWITCH
HOUSING
SCREWS
Figure #1
14
Switch Housing
Light Kit Gasket
Gasket
Switch Housing
Adapter Plate
Screws (3)
Screws (4)
Adapter Plate
Light Kit
Cover Plate
Screws (3)
Screw (1)
Figure #2
Figure #3
Cover Plate Cap
Fandangle (3)
Light Kit Pull Chain (1)
SWITCH
HOUSING
SCREWS