Blade & Blade Holder Installation; Switch Housing Installation - Casablanca COTTAGE Owner's Manual

BLADE & BLADE HOLDER INSTALLATION
Step 11b. Using two screws from screw pack "C" and
the screwdriver provided; attach the blade/blade holder
assembly to the motor. Tighten securely by hand only.
TIP: For balancing purposes, loosely install all fi ve blades
to the motor before tightening the blade screws securely.
CAUTION:
Blade screws must be tightened securely before
operating the fan.
Preparation
Step 12. Locate the switch housing cap assembly and
remove the two 8-32 x 3/8" screws holding the cap onto
the switch housing.
NOTE: Save the two screws — they will be used in Step
13.
Install the Switch Housing Mounting Screws
Step 13a. Locate the two dummy switch housing screws
you removed in Step 12. Install them onto the motor as
shown, leaving approximately 1/8" of the threads exposed
for installation of the switch housing.
Step 13b. Line up the two keyholes in the switch housing
cup with the two screws installed in step 13a.
Step 13c. Rotate the cup so that the screws are aligned
with the smaller side of they keyholes. Tighten the screws
securely by hand only.
Install the Switch Housing Cap
Step 14. Line up the two clearance holes in the cap with the
two threaded holes on the raised rim of the switch housing.
Press the cap onto the switch housing to seat the guide pins
into the alignment holes of the switch housing.

SWITCH HOUSING INSTALLATION

™
C
OTTAGE
9