Hanging The Fan - Casablanca CHELSEA Owner's Manual

Step 6c. Using the provided Allen wrench (attached to
the paper motor warning shield), loosen the Allen set screw
from the hanger adaptor. Insert the downrod into the
motor coupling and turn it clockwise until it stops turning,
ensuring that the pole has bottomed out.
Step 6d. Tighten the set screw with the provided Allen
wrench to ensure safe operation of your fan. If it is tight
enough, you should not be able to turn the downrod
counterclockwise with your hands. If in doubt, tighten
the set screw with the Allen wrench until you cannot turn
it any further.
CAUTION: Failure to fully lock in the downrod
before securely tightening the Allen set screw may
cause the fan to separate from the downrod and fall
during normal operation.
Install Incandescent Lightbulbs
Step 7. Screw in four 25-watt incandescent lightbulbs as
shown.
NOTE: When replacing lightbulbs, be sure to use only
25-watt maximum.
Step 8a. To hang the fan body in the canopy, hold the fan
body firmly and insert the ball into the canopy opening.
Check that no wires were pinched. Rotate the fan body
until the slot in the ball fits into the pin opposite the
canopy opening.
Step 8b. Trim excess motor wires, leaving at least 6 inches
above the downrod. Strip 1 / -inch insulation from the end
2
of each wire using a wire stripper (available at your local
hardware store).
FAN PREPARATION (CONT.)
Caution Shield

HANGING THE FAN

C C C C C
HELSEA HE HE
HE HE
Motor Wires
(leave at least 6" long)
Allen Wrench
Allen
Set Screw
DANGER
IT IS IMPERITIVE THAT THE LOCKSCREW
BE SET TIGHTLY AGAINST THE DOWNROD
THREADS AFTER FAN IS ASSEMBLED
FAILURE TO DO SO WILL CAUSE FAN TO FALL
DO NOT OIL SEALED BEARINGS!
INSTALLER INSTALLER
GIVE THIS TAG TO THE CONFIRM LOCKSCREW
CONSUMER AFTER IS PROPERLY TIGHTENED
INSTALLATION COMPLETE
P/N 1942640 SRB4/96
TIGHTEN
TIGHTEN
LOCKSCREW LOCKSCREW
CAUTION
DAMP LOCATION RATED FANS
REQUIRE A GROUND FAULT INTERRUPTER (GFI)
USE A WEATHER PROOF OUTLET BOX
PROPERLY CONNECT GROUND WIRES
USE ONLY UNDER A WEATHER
PROOF STRUCTURE
Ball
Slot
™ ™ ™ ™ ™
LSEA LSEA LSEA
LSEA
Ground Wire
(green)
Perma•Lock™ Downrod
and Ball Assembly
Tapered Thread
Motor
Coupling
Motor Housing
Assembly
Pin
7