Advertisement
6. Yoke & downrod assembly
6. Yoke & downrod assembly
6a.
Lead Wires
6b.
Downrod
Cross Pin
7. Hanging the fan
7. Hanging the fan
(1)
Lift fan assembly onto mounting bracket.
8. Make wire connections - For use with remote controller
8. Make wire connections - For use with remote controller
8-1. Prepare Remote Control
Transmitter
Code Switches
This unit has 16 different code combinations.
1.Setting the code on the TRANSMITTER
A. Remove battery cover.
B. Slide code switches to your choice of ON or OFF position. Use a small screwdriver or
ball point pen to slide each switch firmly up or down.
C. Install 9V DC battery ( not included ).
D. Install battery cover on transmitter.
2.Slide code switches "on the receiver " to be the SAME POSITIONS as you have set on the transmitter.
Canopy
1.Insert the Yoke Cover and Canopy through downrod
Downrod
assembly as shown above.
Yoke Cover
2.Feed motor lead wires through downrod assembly.
3.Insert the downrod assembly into yoke.
Yoke
Set Screws(2)
1.Insert the cross pin through Yoke and downrod and secure
with Cotter Pin.
Cotter Pin
2.Tighten both set screws to further secure downrod.
3.Tighten hex nuts existing on set screws toward yoke to prevent
set screws from loosening.
4.Pull down the yoke cover on top of housing to cover the yoke.
Hex nut(2)
Mounting
Bracket
Mounting
Bracket
Ball Notch
(2)
Carefully lift fan assembly onto mounting bracket.
Rotate fan so that the notch on the ball engages the
ridge in the mounting bracket.
Receiver
Code Switches
P3
Advertisement
