Assembling And Hanging The Fan - Casablanca Tribeca Owner's Manual And Installation Manual

WARNING: Fan may fall if not assembled as directed in these
installation instructions .
You can assemble your fan for standard or angled mounting as
shown in steps below .
3-1 . Unbundle the wires from the fan .
3-2 . Feed the wires from the fan through the downrod .
Note: Make sure all the wires are on the same side of the metal
dowel pin inside the downrod .
3-3 . Loosen the square head setscrew on the adapter in order to
install the downrod .
3-4 . Insert the downrod into the adapter . Tighten by turning the
downrod assembly at least 4-5 full turns until it stops .
Note: When the downrod assembly is fully installed, 2-3 threads
on the pipe will still be visible; this is normal . Securely
retighten the setscrew with a wrench or pliers .
WARNING: If the setscrew is not tightened securely, the fan
may fall .
3-5 . (Optional) - The wires can be cut (shortened), but leave at
least 8" extending from the top of the downrod .
3-6 . Raise the fan and place the downrod ball into the ceiling bracket .
3 • Assembling and Hanging the Fan
M6000-01 • 08/22/14 • Casablanca Fan Company
Setscrew
Steps 3-1 – 3-4
Step 3-6
8
Downrod
Canopy
Adapter
For angled ceilings, point
opening toward peak
Ceiling
Bracket
Downrod