Installing The Quick-Release Levers; Attaching The Wheels - Burley ENCORE Owner's Instruction Manual

III.

Installing the Quick-Release Levers

In the bag with the refl ectors you'll fi nd two quick-release levers. Install
these through the hollow axle of the wheel. Make sure the lever is on the
nutted side of the wheel, and the long axle and the thumb nut on the other
side. This keeps the wheel away from the fabric side panel. The springs are
mounted on each side as shown in the il lus tra tion below.
The quick-release lever
must be on the fl at side
of wheel, and thumb nut
on the opposite side. This
ensures that the lever will
be on the outside when
wheel is properly installed.
IV.

Attaching the Wheels

First, verify that the tires are infl ated to 30–35 P.S.I. Next, tip the trailer frame
on its back end. If you are work ing on a rough or dirty sur face, lay down a
cloth or other protective barrier to avoid damage to your trailer. Move the
quick-release lever to the unlocked position and place the wheels into the
dropouts, making certain that the axles go all the way into the slots.
Correct
4
Burley Encore Owner's Instruction and Safety Manual
Flat
Thumb Nut
The quick-release
lever and fl at side
of the wheel must
be in stalled toward
the outside of the
trailer.
Wrong
Quick
Release
Lever