Installing The Wheel Guards; Installing The Tow Bar; Removing The Tow Bar - Burley Encore Owner's Instruction & Safety Manual

Installing the Wheel Guards

1. Position the wheel guard as shown (Figure 7).
2. Slide the wheel guard into the tow bar receiver until it
snaps into place (Figure 8). Lightly bend front tabs inward
when inserting.
3. Repeat on other side.

Installing the Tow Bar

1. Slide the tow bar into the tow bar receivers until hole A is
aligned with hole B (Figure 9). The red safety collar must
be flush with the front of the tow bar receiver, which
indicates that the tow bar has been fully inserted.
2. Insert the retaining pin from the top through the aligned
holes (Figure 10).
3. Make sure the retaining pin has locked properly as
shown (Figure 11).
4. Clip the safety strap to the D-ring on the trailer frame
(Figure 12).

Removing the Tow Bar

1. Remove the retaining pin, and unclip the safety strap
2. Press the tab on the wheel guard to depress the detent,
and remove the tow bar.
Figure 9
6
ENG
A B
Figure 11
Figure 10
Figure 7
CHILD TRAILER
Figure 8
Figure 12