Burley ENCORE Owner's Instruction Manual page 8

Stroller Use (requires optional Walk n' Roller™ kit)
Your Burley Encore is
ready for stroller use
with the purchase
of the optional Walk
'n Roller™ kit from
your local bike shop.
For strolling, slide the
tongue back until the
stroller pin hole on the
tongue lines up with
the hole in the rear
tongue mount. Depress
the safety button a
second time to allow the tongue to slide past the rear tongue mount. Be sure to
replace the pin through the rear tongue mount and the tongue, and then en-
gage the pin's clip. This option brings the stroller wheel closer to the main body
to stroller easily in tight spaces.
DO NOT attempt to attach the bicycle with the tongue in the stroller
position. There will not be adequate clearance for a bicycle wheel.
Installation and Use of the Handle
Your Burley Encore comes with a two-position handle that allows for easier ma-
neuvering of the trailer when it is not attached to your bicycle. The handle is also
an important part of the optional Burley Jogger Kit ™ and the optional Walk 'n
Roller™ kit. Both of these accessories are available at your local bike shop.
The handle for the Encore is installed quite easily. Simply depress the buttons
on either side of the handle and slide the handle into the handle bar receivers as
shown in the illustration below. The handle is designed for either a high or low
position depending on the height and comfort of the user. This position can be
changed by fl ipping the handle over and installing it as described above.
8
Burley Encore Owner's Instruction and Safety Manual
Tongue in Trailer
position
Pin locked through
Rear Tongue Mount
and Trailer Pin hole