Installing The Jogger On Your Trailer - Burley Jogger Kit Owner's Instruction & Safety Manual

Installing the Jogger on Your Trailer

1. Observe (Figure 1) to see completed installation. Note the
downward curve of the bars and the orientation.
2. Slide the jogger arms into the receiver on both sides. Refer
to your trailer manual for directions on how to properly
secure products for your specific trailer receiver.
3. Pull on the jogger arms to ensure they are securely
attached to the receivers.
4. Insert the quick release lever skewer through the hub of
the wheel, making sure there is a spring on either side of
the hub. Screw the nut on loosely (Figure 2).
5. Place the wheel in the wheel dropouts (Figure 3).
6. With the QR handle pointing away from the wheel, tighten
the nut so that you feel resistance halfway through
closing the lever. Do not tighten the quick release lever by
spinning the lever.
7. Close the quick release lever. The lever should point
downward.
8. Make sure your handlebar is at the right height for jogging.
If necessary, adjust the handlebar to a better height. See
trailer manual to adjust your handlebar.
4
ENG
Figure 1
Figure 2
Figure 3
JOGGER KIT