Completing Assembly - Burley ENCORE Owner's Instruction Manual

4. Ensure that the shoulder straps are adjusted so that the child is comfort-
ably kept from moving too far forward in the seat.
5. Fasten and adjust the lap belt so that it is snug.
6. Repeat steps 1-5 for the second child.
Child and cyclist must wear hel mets when trailering. Helmets can
prevent or signifi cantly reduce head injury in event of accident.
IMPORTANT: Connect the snap hooks on the back of the seat to the
D-rings at the rear of the side panels in the cargo area. Only release
the right snap hook when folding the trailer.
VII. Completing Assembly
At this time your trailer is near ly assembled. Snap the fabric tail gate and
splash guard to the upper snap studs on the side rails if you haven't already
done so. It's easier to snap these when the trailer is folded, and they can
remain snapped in place during folding and un fold ing.
Your 2-in-1 Cover is held in place by eight snaps at the front, rear, and top.
Note that the cover has a front and a rear; the tinted window goes to the rear
of the trailer . Al ways use your cover to keep debris out (and toys inside) of
the trailer when it's in tow.
You're done! Please go back over these directions and recheck your work.
IMPORTANT: Read and study sec tions "VIII. Hitching the Burley Encore
to Your Bicycle," "Safety Guidelines," and "Safety Checklists" before
using your Burley Encore.
12
Burley Encore Owner's Instruction and Safety Manual