Burley ENCORE Owner's Instruction Manual page 5

IMPORTANT: Wheels must be in stalled so that tires are offset away
from side panels, closest to outer frame. Bolts sticking out from inner
frame at rear are designed to interfere with improper installation of
wheel. These wheels are a unique feature of Burley trailers; they cre-
ate a wider track, and thus a more stable trailer.
Once the wheels are fully seated in the dropout slots, the quick-release lever
should be positioned so that it operates in the fore and aft direction. The
lever is marked for open or closed po si tions. Tighten the right-hand wheel
by moving the lever from the front (open) to the rear (closed) position.
Tighten the left-hand wheel by moving the lever from the rear (open) to the
front (closed) position. Use the thumb nut to adjust for correct spacing of the
quick-release lever.
When properly ad just ed, you will feel re sis tance halfway through tight en ing
the lever (when the lever is pointing straight out away from the trailer). If you
are unfamiliar with the use of quick-release levers, contact your Burley dealer
for a demonstration.
The quick-release lever
op er ates in fore-aft di rec tion
(with lever below the axle).
The drawing shows left-hand
wheel in the closed po si tion.
Make sure wheels are held securely; you should not be able to
rock or shift wheels. Improperly installed wheels can fall off, caus-
ing accident and serious injury.
Only use the 20 x 1.75 wheels supplied with Burley Encore. Do not
operate with tires in fl at ed above 35 P.S.I. Failure to comply can
cause trailer tip over, resulting in accident and serious injury to
cyclist or pas sen gers.
Burley Encore Owner's Instruction and Safety Manual
5