Hardware Bag Contents And Tool List; Mounting The Refl Ectors; Installing The Quick-Release Levers - Burley FLATBED Owner's Instruction Manual

I.

Hardware Bag Contents and Tool List

IMPORTANT: Please verify that you have received all of the
con tents listed. Do not proceed with as sem bly if any parts are
miss ing; contact Burley im me di ate ly for replacement parts.
Hardware Bag Contents
Refl ectors:
(2) Rear refl ector, red
(2) Self-tapping screw, refl ector
Envelope:
Trailer Checklist
Warranty Card
Burley Flatbed Owner's Instruction & Safety Manual
II. Mounting the Refl ectors
Fasten the refl ectors to the brack ets located on the rear of the main
frame using the self-tapping screws found in the hardware bag. (Note the
des ig na tion "Top" on the back of each refl ector.)
III.

Installing the Quick-Release Levers

In the bag with the refl ectors you'll fi nd two quick-release levers. Install these
through the hollow axle of the wheel. Make sure the lever is on the fl at side
of the wheel, the thumb nut is on the deep-dished side, and the springs are
mounted on each side as shown in the illustration be low.
The quick-release lever must
be on fl at side of wheel and thumb
nut on deep-dished side. This
ensures that the lever will be on
the outside when wheel is properly
installed.
Quick-Release Levers:
(2) Quick-release lever
(2) Pair tie-down straps
Tools Required:
5/16", 8mm or small ad just able wrench
Deep
Dish
Thumb
Nut
Burley Flatbed Owner's Instruction and Safety Manual
Flat
Quick
Release
Lever
3