Opening Your Trailer; Closing Your Trailer; Installing Wheel Guards; Attaching The Wheels - Burley Bee Homeowner's Instructions

Opening Your Trailer

Opening Your Trailer
1
Lift front frame at rear.
cHEcK tHAt tHE FrAME LAtcHES ArE ProPErLY EnGAGEd BEForE uSInG trAILEr.

Closing Your Trailer

1
remove passengers and
cargo, and then remove the
tow bar and both wheels.
4.
4.
cArE MuSt BE tAKEn WHEn FoLdInG And unFoLdInG to PrEVEnt FInGEr EntrAPMEnt.
BEE
2
raise the rear frame tube until the tubes
sit together on the plastic saddles.
WARNING
2
From the rear of the trailer, lift the
cover. While depressing the latch
release button, lift the yellow latches.
WARNING
3
Lock bars together by pushing
down on the yellow latches.
note
If right latch will not rotate freely,
depress button to allow latch to
rotate forward.
3
Push the rear frame at the
lower bend to fold flat.
note
damage to windows can occur if
trailer is folded with wheels installed.
Installing the Wheel Guards
1
Insert the the wheel guard into the reciever. Slide the
wheel guard back until you hear it click into place.
repeat for other side.
Attaching & Removing
the Wheels
1
While pressing rubber For removing wheel:
button, insert wheel axle while pressing button,
into axle receiver, and slide wheel out of the axle
then release the button. receiver. release button.
Pull firmly on wheel to
confirm the axle is fully
engaged.
ASSEMBLY & uSE
2
5