AEG 6130 V-w Instruction Book page 60

Installation of anti-tilt device
The anti-tilt device prevents the
cooker tipping forward.
What to do:
1. Screw the attached angle fitting to
the floor as shown.
2. Take the drawer out of the cooker
and push the cooker into place.
3. Insert and tighten the screw
provided in the hole in the angle
fitting by stretching the arms into
the space left by the drawer.
4. Replace the drawer.
The anti-tilt device must be
mounted and will work only
when the cooker is pushed into
place and the screw is mounted.
Levelling
Check the cooker is level with a spirit
level.
Set the spirit level on the hob edges
(front edge, side edges, rear edge).
Level up the cooker with the wheels
and adjustment feet.
The wheels are located in the rear
corners of the plinth and can be
continuously adjusted from the front
of the plinth. Adjust the wheels with
a screwdriver through the holes in the
plinth. Adjust the adjustment feet at
the front with the fingers.
Floor
60
Wall
Anti-tilt
protection
90 mm