Call Transfer - Yealink SIP-T46G User Manual

When the monitored line receives an incoming call, the followings occur on the phone:
The phone plays a warning tone (if enabled).

The BLF key LED flashes red.

The caller ID appears on the LCD screen (if enabled).

In the following figure, the LCD screen shows an incoming call from 3606 on the
monitored line.
Note
If your phone is locked and the type of the keypad lock is configured as Function Keys or
All Keys, you cannot use the Pickup, Dial, NewCall and Cancel soft keys until unlocked.
When there is an active call on the IP phone, you can transfer the active call to the
monitored phone number directly by pressing the BLF key. The phone transfers the
active call differently depending on the transfer mode via DSS key. For more
information on performing call transfer, refer to
To configure the transfer mode via DSS key via web user interface:
1. Click on Features->Transfer.
2. Select the desired transfer mode from the pull-down list of Transfer Mode Via
Dsskey. Depending on your selection:
If you select Blind Transfer, press the BLF key to blind transfer the call to the
monitored phone number.
If you select Attended Transfer, press the BLF key to dial out the monitored phone
number. Then you can perform the attended or semi-attended transfer.
Advanced Phone Features

Call Transfer

on page 105.
119