Press STOP to continue.
Batches are numbered
1 (top switch)
and 2 (bottom switch)
Next, the first batch parameter is displayed – batch 1, brew volume
Use the UP and DOWN buttons to adjust.
• Press the STOP button to go to the next parameter – brew time.
Repeat the last step until all parameters are programmed for batch #1.
(See the chart below for an explanation of each parameter.)
Next, batch #2 programming begins.
Batch 2 may be disabled by leaving it set to "OFF".
Change to "ON" to enable. Batch 1 cannot be disabled.
After both batches are programmed, the temperature settings are next.
Display: 1.2 04.00