Programming- Operator Access Programming; Batch Settings - Fetco Extractor CBS-2061e User Manual

Programming- operator access programming

Batch Settings

Turn the brewer off by pressing the main power switch.
Press the main power switch again to turn the unit on.
The last 2 digits of the model number will display briefly, then S t b.
Quickly hold the STOP button for 3 seconds.
The display will show the software version. Example:
Press STOP to continue. Press STOP again to exit.
Batches are numbered 1 – 3
Next, the first batch parameter is displayed – batch 1, brew volume
Use the SCROLL UP and SCROLL DOWN buttons to adjust.
Press the STOP button to go to the next parameter – brew time.
Continue this way until all parameters are programmed for batch #1.
(See the chart below for an explanation of each parameter.)
Next, batch #2 programming begins.
Batches 2, 3, 5, and 6 may be disabled by leaving them set to "OFF".
Change to "ON" to enable. Batches 1 and 4 cannot be disabled.
After all batches are programmed, go to temperature settings.
Important! After programming, you must press the HOT WATER button to save the settings and exit
programming mode, or changes will be lost. You may exit programming at any time.
!!! ►If you press the wrong button turn power switch "OFF" and begin programming again!!!
Batch Parameters
X=Batch Number (1 - 6)
Parameter Nene
Batch
0
X.
Enabled/Disabled
1 Brew Volume (Gallons)
X.
2
Brew Time (Min:Sec)
X.
3 Bypass Percent
X.
4 Prewet Percent
X.
5
X. Prewet Delay (Min:Sec)
6
Drip Delay (Min:Sec)
X.
Programming instruction table continued on the following page
or 1 – 6
(CBS-2061e)
PARAMETER
BATCH #
1.1 3.00
Example:
Left Side – Large Batch – Volume 3.0 Gal.
Range
On/Off
0.5 – 4.00
3:00 – 15:00
0.00 – 40.0%
0.00 – 15.0%
0:10 – 5:00
Units: min/sec
1:00 – 8:00
Units: min/sec
Display
S t b
0.0 4.8
(CBS-2062e)
SETTING
1.1 3.00
1.2 4.30
2.0 OFF
7
(See next page)
Increment Default Setting
Batch 1 & 4 = ON
1-6
Batch
2, 3, 5, 6 = OFF
0.01 3 gal. (2061e/2062e)
0:30 4:30 minutes:seconds
1% 0 %
1% 0 %
0:10 1:00 minutes:seconds
0:10 4:00 minutes:seconds
9
62
P r G
CBS-2062e
200
Comment
Batch 1 & 4 cannot be
disabled.
To display liters, see # 59 in
Advanced Settings section.
Add brew time to drip delay
time and prewet for time of one
batch.
Percentage of total
brew volume
Percentage of total
brew volume
The time between prewetting
and start of brew cycle.
The time between end of brew
cycle and unlocking of brew
basket.