Programming; Batch Settings - Fetco CBS-2041e User Manual

Fetco cbs-2041e: users guide
Hide thumbs Also See for CBS-2041e:
Table of Contents

Advertisement

Batch Settings

Turn the brewer off by pressing the main power switch.
Press the main power switch again to turn the unit on.
Quickly hold the STOP button for 3 seconds.
The display will show the software version for 3 seconds. Example:
Batches are numbered 1 – 2 (CBS-2041) or 1 – 4 (CBS-2042)
Next, the first batch parameter is displayed – batch 1, brew volume
Use the SCROLL UP and SCROLL DOWN buttons to adjust.
Press the STOP button to go to the next parameter – brew time.
Continue this way until all parameters are programmed for batch #1.
(See the chart below for an explanation of each parameter.)
Next, batch #2 programming begins.
Batches 2 and 4 may be disabled by leaving them set to "OFF".
Change to "ON" to enable. Batches 1 and 3 cannot be disabled.
After all batches are programmed, go to temperature settings.
Important! After programming, you must press the HOT WATER button to save the settings and exit programming
mode, or changes will be lost. You may exit programming at any time.
Batch Parameters
X=Batch Number (1 - 4)
Parameter
Name
X.0
Batch Enabled or
Disabled
X.1
Brew Volume
(Gallons)
X.2
Brew Time (Min:Sec)
X.3
Bypass Percent
X.4
Prewet Percent
X.5
Prewet Delay
(Min:Sec)
X.6
Drip Delay (Min:Sec)

Programming

BATCH #
1.1
Example: Left Side – Large Batch – Brew Volume 1.0 Gal.
Range
On/Off
0.25 – 1.25
2:00 – 24:00
0.00 – 40.0%
0.00 – 15.0%
0:10 – 5:00
0:30 – 6:00
Minutes
PARAMETER
SETTING
1.00
(See next page)
Increment
Default Setting
Batch 1 & 3 = ON
Batch 2 & 4 = OFF
0.01
1.0 gallons
0:30
4:00 minutes
1%
0 %
1%
0 %
0:10
1:00 minute
0:10
1:30 minute
9
Display
S t b y
P r G
0.0 2.11
DISPLAY
ADVANCE
TO NEXT
PARAMETER
1.1 1.00
SCROLL UP
1.2 4.00
SCROLL
DOWN
SAVE
CHANGES
AND EXIT
2.0 OFF
7
200
Comment
Batch 1 & 3 cannot
be disabled.
To display liters, see
# 59 in Advanced
Settings section.
Percentage of total
brew volume
Percentage of total
brew volume
The time between
prewetting and start
of brew cycle.
The time between
end of brew cycle
and unlocking of
brew basket.
MAIN POWER
SWITCH IS
BEHIND
FRONT LEG.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cbs-2042eExtractor cbs-2041Extractor cbs-2042

Table of Contents