Programming; Batch Settings - Fetco CBS-2051e User Manual

Batch Settings

Turn the brewer off by pressing the main power switch.
Press the main power switch again to turn the unit on.
Quickly hold the STOP button for 3 seconds.
The display will show the software version for 3 seconds. Example:
Batches are numbered 1 – 3 (CBS-2051) or 1 – 6 (CBS-2052)
Next, the first batch parameter is displayed – batch 1, brew volume
Use the SCROLL UP and SCROLL DOWN buttons to adjust.
Press the STOP button to go to the next parameter – brew time.
Continue this way until all parameters are programmed for batch #1.
(See the chart below for an explanation of each parameter.)
Next, batch #2 programming begins.
Batches 2, 3, 5, and 6 may be disabled by leaving them set to "OFF".
Change to "ON" to enable. Batches 1 and 4 cannot be disabled.
After all batches are programmed, go to temperature settings.
Important! After programming, you must press the HOT WATER button to save the settings and exit
programming mode, or changes will be lost. You may exit programming at any time.
Batch Parameters
X=Batch Number (1 - 6)
Parameter Name
X.0 Batch Enabled or
Disabled
X.1 Brew Volume
(Gallons)
X.2 Brew Time (Min:Sec)
X.3 Bypass Percent
X.4 Prewet Percent
X.5 Prewet Delay
(Min:Sec)
X.6 Drip Delay (Min:Sec)

Programming

PARAMETER
BATCH #
1.1
Example:
Left Side – Large Batch – Brew Volume 1.5 Gal.
Range
On/Off
0.25 – 3.00
2:00 – 24:00
0.00 – 40.0%
0.00 – 15.0%
0:10 – 5:00
0:30 – 6:00
Minutes
0.0 1.35
SETTING
1.50
1.1 1.50
1.2 4.00
2.0 OFF
7
(See next page)
Increment Default Setting
Batch 1 & 4 = ON
Batch 2, 3, 5, 6 = OFF
0.01 1.5 gallons
0:30 4:00 minutes
1% 0 %
1% 0 %
0:10 1:00 minute
0:10 1:30 minute
9
Display
S t b y
P r G
MAIN POWER
DISPLAY
ADVANCE
TO NEXT
PARAMETER
SCROLL UP
SCROLL
DOWN
SAVE
CHANGES
AND EXIT
200
Comment
Batch 1 & 4 cannot
be disabled.
To display liters, see
# 59 in Advanced
Settings section.
Percentage of total
brew volume
Percentage of total
brew volume
The time between
prewetting and start
of brew cycle.
The time between
end of brew cycle
and unlocking of
brew basket.
SWITCH IS
BEHIND
FRONT LEG.