Test Mode - Intermec EasyCoder PC4 User Manual

Test Mode

The Test Mode can be used for four main purposes:
• To adjust the Label Gap Sensor.
• To print a Test Label with a test pattern and a list of the printer's cur-
rent setup.
• To enter the Dump Mode.
• To reset the printer to its default settings.
Do not use continuous stock in the Test Mode. The printer
will not be able to detect any gaps and an error will occur.
Use the Test Mode this way:
After having loaded the printer with full width labels, tickets, or tags,
1
switch off the power to the printer.
Press and hold the Feed key while switching on the power.
2
Release the Feed key when the green indicator lamp flashes.
3
The printer will automatically adjust the label gap sensor and media
4
feed according to the characteristics of the media. The printer may
feed out 3-4 forms before the adjustment is completed. In case of
peel-off operation, remove the labels as they are fed out.
After a delay, a Test Label will be printed and the printer will be
5
placed in the Dump Mode (see Intermec Esim v6.XX, Programmer's
Reference Manual).
Tap the Feed key once to switch back to normal operation, or...
6a
...reset the printer to default setup values by pressing and holding the
6b
Feed key for at least three seconds after the test label was printed. The
indicator lamp will switch to red to indicate that the printer was reset
to default setup. Restart the printer by switching off the power and
then switching it on again.
Refer to the Intermec ESim v6.XX, Programmer's Reference Manual for
illustration and explanation of the test label.
EasyCoder PC4 User's Guide
Chapter 3 — Operation
29