Instructions
Using a PC
Install the Intermec EasyCoder PC4 Config Tool in your PC.
1
Run the PC4Conf.exe program.
2
Set up the parameters for the firmware download. Use the on-line
3
help for instructions.
Start the Firmware download wizard and follow the instructions on
4
the screen.
Using a Memory Cartridge
Switch off the printer.
1
Move the switch on the side of the cartridge to the upper position.
2
Firmware down-
load position
Normal position
Insert the cartridge.
3
Switch on the printer. The indicator lamp will start blinking during
4
the upgrading. Wait until the blinking stops, which takes about 40
seconds.
Switch off the printer and remove the memory cartridge. Put back the
5
cover over the memory cartridge slot.
If the cartridge is removed at an angle, the connector pins
may be bent.
EasyCoder PC4 User's Guide
Appendix D — Firmware Upgrading
57