Scan Operation; I Scan Operation; Normal Scan - Icom IC-A110EURO Instruction Manual

I Scan operation

q Push [V/M] to select memory mode or VFO mode, if nec-
essary.
• " " appears on the memory mode.
w Make sure the squelch level is set to the threshold point.
• Set a squelch level (01 to 25) where the noise is muted.
e Push [SCAN] to start scan.
• To change the scan direction, turn [DIAL].
• "SCAN (or P SCAN)" flashes while scanning.
r Push [SCAN] again to stop the scan.
NOTE: Normal scan or Priority scan is pre-programmed
by cloning. Please ask your dealer or system operator for
details.
ï NORMAL SCAN
•Memory lock scan
Repeatedly scans memory
channels except skip (lockout)
channels.
Mch 1
Mch 2*
SKIP
Mch 3
Mch 20
*: Lockout ch
250 msec.

SCAN OPERATION

• VFO scan
Repeatedly scans all
frequencies over the entire
band. Scan step is minimum
channel spacing. (e.g. 25 kHz or
8.33 kHz)
ï PRIORITY SCAN
•Priority memory scan
While scanning on a memory
mode, priority watch checks
for a signal on the selected
priority channel every 250 m
sec except lockout channel.
3
lowest
highest
Start
frequency frequency
Scan
Jump
250 msec.
250 msec.
Mch 1
SKIP Mch 2*
Priority
ch
Mch 3
Mch 20
*: Lockout ch
6