Furuno SC-50S Operator's Manual page 38

2. OPERATION
5. Choose SENTENCE and then press the ENT key.
6. Use the Omnipad to choose a sentence and then press the ENT key.
HDT: True heading (required for radar, AIS, ECDIS, etc.)
HDM: Magnetic heading (HDM is obtained in this equipment by adding the
ROT: Rate-of-turn data
ATT:
VDR: Set and drift
VTG: Course over ground and ground speed
GGA: Global positioning system (GPS) fix data
GNS: GNSS fix data
GLL:
VHW: Water speed and heading
VBW: Dual ground/water speed
HVE: GPS antenna up-down motion amplitude (FURUNO proprietary
ZDA:
7. Use the Omnipad to choose OFF or ON as appropriate and then press the
ENT key. Sentences selected for output are marked with an asterisk.
8. Repeat steps 6 and 7 for other items. All sentences cannot be selected. The
message "SENTENCE OVERLOAD" appears when too many sentences
have been selected. Change settings as appropriate. For further information
see page 2-12.
9. Press the MENU key to return to the DATA OUT1 menu.
10. Choose BAUD RATE and then press the ENT key.
2-10
HDT
HDM
ROT
ATT
VDR
DATA OUT1 menu, sentences
magnetic variation to HDT.)
True heading, pitching, rolling (FURUNO's proprietary sentence)
Geographic position, latitude/longitude
sentence)
Time and date
Baud rate options
DATA OUT1
VTG VHW
GGA VBW
GNS HVE
GLL ZDA
OFF
ON
4800BPS
9600BPS
19200BPS
38400BPS