Furuno SC-50S Operator's Manual page 24

1. INSTALLATION
How to attach connector N-P-8DFB
Outer Sheath
Cover with heat-shrink tubing and heat.
1-18
Armor Inner Sheath Shield
30
50
Clamp
Clamp Nut Gasket
(reddish
Aluminum Foil
brown)
Trim shield here.
Insulator
Trim aluminum
tape foil here.
1
5
Pin
Clamp Nut
Solder through
the hole.
How to attach connector N-P-8DFB
(Dimensions in millimeters.)
Cut off insulator and core by 10 mm.
10
Twist shield end.
Slip on clamp nut,
gasket and clamp as shown left.
Fold back shield over clamp and trim.
Cut aluminum foil at four places,
90 from one another.
Fold back aluminum foil onto shield
and trim.
Expose the insulator by 1 mm.
Expose the core by 5 mm.
Shell
Slip the pin onto the conductor.
Solder them together through the
hole on the pin.
Insert the pin into the shell.
Screw the clamp nut into the shell.
(Tighten by turning the clamp nut.
Do not tighten by turning the shell.)