Testing Your Setup; Default Router Settings; Table 3.2. Default Settings Summary - Asus RX3041H User Manual

Chapter 3. Quick Start Guide
•
Enter Subnet Mask for the WAN. This information should be provided by your ISP.
Typically, it is 255.255.255.0.
•
Enter gateway address provided by your ISP in the space provided.
•
Enter at lease the primary DNS IP address provided by your ISP. Secondary DNS IP
address is optional. Enter it in the space provided if you have such information from your
ISP.
•
Click
You have now completed customizing basic configuration settings. Read the following section to determine if
you have access to the Internet.
3.3.3

Testing Your Setup

At this point, the RX3041H should enable any computer on your LAN to use the RX3041H's ADSL or cable
modem connection to access the Internet.
To test the Internet connection, open your web browser, and type the URL of any external website (such as
http://www.asus.com). The LED labeled WAN should be blinking rapidly and may appear solid as the
connects to the site. You should also be able to browse the web site through your web browser.
If the LEDs do not illuminate as expected or the web page does not display, see Appendix D for
troubleshooting suggestions.
3.3.4

Default Router Settings

In addition to handling the DSL connection to your ISP, the router provides a variety of services to your
network. The device is pre-configured with default settings for use with a typical home or small office network.
Table 3.2 lists some of the most important default settings; these and other features are described fully in the
subsequent chapters. For a complete list of default settings, please refer to the section B.2 "Default Settings". If
you are familiar with network configuration settings, review the settings in Table 3.2 to verify that they meet the
needs of your network. Follow the instructions to change them if necessary. If you are unfamiliar with these
settings, try using the device without modification.
Before modifying any settings, review Chapter 4 for general information about accessing and using the
Configuration Manager.
Option
DHCP (Dynamic DHCP server enabled with the
Host following pool of addresses:
Configuration
192.168.1.10 through 192.168.1.200
Protocol)
LAN Port IP Static IP address: 192.168.1.1
Address
subnet mask: 255.255.255.0
20
to save the static IP settings

Table 3.2. Default Settings Summary

Default Setting Explanation/Instructions
The router maintains a pool of private IP
addresses for dynamic assignment to your
LAN computers. To use this service, you
must have set up your computers to
accept IP information dynamically, as
described in Part 2 of the Quick Start
Guide. See section 5.2 for an explanation
of the DHCP service.
This is the IP address of the LAN port on
the RX3041H. The LAN port connects the
device to your Ethernet network. Typically,
you will not need to change this address.
See section 5.1 LAN IP Address for
instructions.
RX3041H User's Manual
device