Table of Contents
Advertisement
Chapter 10. Configuring Remote Access
10.2.5 User Group and Users Configuration Example
Figure 10.2. User Group and Users Configuration Example
Example
Figure 10.2 displays the screen with entries to:
Add a new user group and a new user
•
Group "Sales"
•
User "Alan"
10.3 Configure Group ACL Rules
Group ACL is used to control access privileges for remote or local user groups. Its configuration is similar to
that for firewall inbound/outbound ACL rules, except two additional fields – rule type and group name (see
Table 10.2). For procedures to configure group ACL rules, please refer to section 9.3 or 9.5 for details.
10.3.1 Group ACL Specific Configuration Parameters
Table 10.2 describes the group ACL specific configuration parameters. The rest of the configuration
parameters are the same as those for firewall inbound/outbound ACL rules. Please refer to Table 9.1 for
details on common configuration parameters.
Table 10.2. Group ACL Specific Configuration Parameters
Field
Type
Select the type of traffic to which this rule should apply.
Inbound
Outbound
Group
Select from the group drop-down list to which this rule should apply. Note that to configure a group
ACL rule, a user group must be configured first. Please refer to 10.2 for the configuration of user
groups.
10.3.2 Add a Group ACL Rule
To add a group ACL rule, follow the instructions below:
1. Open the Time Range configuration page by clicking the Firewall
Access
Group ACL menu.
88
Description
Select this if this rule is for inbound traffic.
Select this if this rule is for outbound traffic.
RX3041H User's Manual
Rem
ote
Advertisement
Table of Contents
