Table of Contents
Advertisement
Chapter 9. Configuring Firewall/NAT Settings
Field
IP Address
Subnet
Address
Mask
Range
Begin
End
IP Pool
Destination IP
This option allows you to set the destination network to which this rule should apply. Use the drop-
down list to select one of the following options:
Any
IP Address, Subnet,
Range and IP Pool
Source Port
This option allows you to set the source port to which this rule should apply. Use the drop-down list to
select one of the following options:
Any
Single
Port Number
Range
Begin
End
Destination Port
This option allows you to set the destination port to which this rule should apply. Use the drop-down
list to select one of the following options:
Any
Single, Range
56
Description
Specify the appropriate network address
This option allows you to include all the computers that are connected in an
IP subnet. When this option is selected, the following fields become
available for entry:
Enter the appropriate IP address.
Enter the corresponding subnet mask.
This option allows you to include a range of IP addresses for applying this
rule. The following fields become available for entry when this option is
selected:
Enter the starting IP address of the range
Enter the ending IP address of the range
This option allows you to associate a pre-configured IP pool with this rule.
The available IP pool can be selected from the IP pool drop-down list.
This option allows you to apply this rule to all the computers in the
destination network such as those on the LAN for inbound ACL rules and
those on the Internet for outbound ACL rules.
Select any of these options and enter details as described in the Source IP
section above.
Select this option if you want this rule to apply to all applications with an
arbitrary source port number.
This option allows you to apply this rule to an application with a specific
source port number.
Enter the source port number
Select this option if you want this rule to apply to applications with this port
range. The following fields become available for entry when this option is
selected.
Enter the starting port number of the range
Enter the ending port number of the range
Select this option if you want this rule to apply to all applications with an
arbitrary destination port number.
Select any of these and enter details as described in the Source Port
section above.
RX3041H User's Manual
Advertisement
Table of Contents
