Add A Nat Pool; Modify A Nat Pool; Figure 9.30. Nat Pool Configuration - Asus RX3041H User Manual

RX3041H User's Manual
Field
Interface
Select this type of NAT to specify the Dynamic Interface whose IP address should be used for
subjecting traffic to NAT.
9.8.3.2

Add a NAT Pool

To add a NAT Pool, follow the instructions below:
1. Open the NAT Pool configuration page by clicking the Firewall
Policy List
2. Select "Add New Pool" from the NAT Pool drop-down list.
3. Enter a pool name into the Name field.
4. Select a pool type from the Type drop-down list.
5. If "Static" or "Dynamic" pool type is selected, enter the original IP
addresses (start IP Address, and end IP Address), and mapped IP addresses (start NAT IP
Address and end NAT IP Address). If "Overload" pool type is selected, enter the NAT IP address.
If you want to use the IP address assigned for the WAN port as the NAT IP address, select the
Interface pool type.
6. Click on the
in the NAT Pool List table.
9.8.3.3

Modify a NAT Pool

To modify a NAT Pool, follow the instructions below:
1. Open the NAT Pool configuration page by clicking the Firewall
menu.
2. Click on the
pool from the NAT Pool drop-down list.
3. Make desired changes to any or all of the following fields: Pool name, Pool type and IP address.
Description
NAT Pool menu.
NAT Pool drop-down list

Figure 9.30. NAT Pool configuration

button to create the new NAT pool. The new NAT pool will then be displayed
icon of the NAT pool to be modified in the NAT Pool List table or select the NAT
Chapter 9. Configuring Firewall/NAT Settings
NAT Pool Type drop-down
Policy List NAT Pool
79