Playing Back The Mastering Tracks - Roland VS-1680 User Manual

Chapter 13 CD-RW and Mastering
Playing Back the Mastering
Tracks
Here's how you can verify the audio that was mixed down to
the mastering tracks. You will listen to the mastering tracks.
Tracks 1-16 themselves will not be played.
1. Press [PLAY (DISPLAY)].
2. Press [PAGE] so that [F6] indicates "M ***" (*** is either
Rec, Ply, or Off).
fig.2-11
3. Press [F6] until "M Ply" appears above [F6]. Press [F6]
once more to select this setting. The current status of the
mastering tracks is shown in the display.
fig.2-12.e
Off Record wait Status
For details on the signal flow, see p. 27.
4. Move to the location at which you started the mixdown.
5. Press [
] so that you can view the playlist of the
mastering tracks.
172
fig.2-15
If the bottom line of the display is surrounded by a heavy
line, you can also use the TIME/VALUE dial to check the
playlist of the mastering tracks.
6. Press [PLAY]. The mastering tracks will play back. Use
At this time, the function buttons will perform the following
actions.
Playback Status
7. When playback ends, press [STOP].
Signal flow (routing)
fig.2-16
the master fader to adjust the volume to a comfortable
listening level.
[F1 (ZOOM+)]:Enlarges the playlist display in the track
direction (three levels).
[F2 (ZOOM-)]:Reduces the playlist display in the track
direction (three levels).
[F3 ( )]:Enlarges the playlist display in the time
direction (five levels).
[F4 ( )]:Reduces the playlist display in the time
direction (five levels).
[F5 (WAVE)]:Display the sound level (waveform) that is
recorded in the tracks.
Track 1--16
MIX
Mastering
L R
MIX
TR1
Sw
Track
TR15-16
MASTER OUT
MONITOR OUT
TR16-16
MASTER