Determining Output; Monitor Output Connectors; Aux Connectors - Roland VS-1680 User Manual

Chapter 5 Using the Digital Mixer

Determining Output

The VS-1680 has eight analog output jacks and two stereo
digital outputs. Each of these outputs can have various
signals assigned to them. Use the following procedure to
determine the signal for each output jack or connector.

MONITOR Output Connectors

1. Press [EDIT/SOLO]. The Master Block is displayed.
2. Use [
], [ ], [
cursor to "OUTPUT (MON)." Use the TIME/VALUE
dial to adjust the setting.
fig.11-44a
Mon (Monitor)
This selects what signal is to be assigned to the MONITOR
jacks.
MST:
The signal at the MASTER jacks (MIX bus).
EFX1:
The signal at the EFFECT 1 bus.
EFX2:
The signal at the EFFECT 2 bus.
AUX1/EFX3:
The signal at the AUX1 bus, or EFFECT 3—the EFFECT 3
bus—when a second VS8F-2 effect card is installed in the
VS-1680.
AUX2/EFX4:
The signal at the AUX2 bus, or EFFECT 4—the EFFECT 4
bus—when a second VS8F-2 effect card is installed in the
VS-1680.
AUX3/AUX:
The signal at the AUX3 bus, or AUX—the AUX bus—
when a second VS8F-2 Effect card is installed in the
VS-1680.
REC:
The signal at the RECORDING bus.
ST IN:
The signal assigned to the STEREO IN.
74
], and [ ] to move the
3. Press [F2(Mon)]. If "Mon" does not appear above [F2],
press [PAGE] until "Mon" appears above [F2], and then
press [F2(Mon)].
fig.11-44
Level
Balance
Level
This adjusts the volume level (0-127) for the MONITOR
jack. This is normally adjusted using the MONITOR
knob on the top panel.
Balance
This adjusts the left-right balance (L63-R63) for the
MONITOR jacks.
4. Press [PLAY (DISPLAY)] to return to the Playlist display.

AUX Connectors

1. Press [EDIT/SOLO]. The Master Block is displayed.
2. Press [F3 (AUX.A)]. If "AUX.A" does not appear above
[F3], press [PAGE] until "AUX.A" appears above [F3],
and then press [F3 (AUX.A)].
3. Determine what signal is assigned to the AUX jacks by
turning the TIME/VALUE dial.
fig.11-45
AUX A
This selects which signal is assigned to the AUX A jacks.
EFX1:
The signal at the EFFECT 1 bus.
EFX2:
The signal at the EFFECT 2 bus.
AUX1/EFX3:
The signal at the AUX1 bus, or EFFECT 3 when a second
VS8F-2 effect card is installed in the VS-1680.
AUX2/EFX4:
The signal at the AUX2 bus, or EFFECT 4 when a second
VS8F-2 effect card is installed in the VS-1680.