Connecting Insert Effects In The Master Block - Roland VS-1680 User Manual

Off:
The channel is not routed into the effect.
Ins:
The channel is routed into both channels of the stereo
effect.
InsL:
The channel is routed into the left channel of the
stereo effect.
InsR:
The channel is routed into the right channel of the
stereo effect.
InsS:
The channel is routed into both channels of the stereo
effect, in series.
fig.05-05
Ins
EQ
(2band, 3band)
InsL
EQ
(2band, 3band)
InsR
EQ
(2band, 3band)
InsS
EQ
(2band, 3band)
* When Ins or InsS is selected, that effect cannot be used on any
other channel. When InsL or InsR is selected, that effect can be
inserted only on one other mixer channel. If the effect is
already being used as an insert effect, the display shows you
the channel on which the effect is inserted, as shown in the
following illustration.
L L
EFX
R R
L L
EFX
EFX
R R
L L
EFX
R R
Chapter 7 Using Internal Effects (VS8F-2)
When EFX1 is used in Track 6
The way you insert an effect can help you utilize the VS8F-2
effect processors to their fullest potential. For example, the
InsL and InsR options allow you to insert separate
compressors (using the Stereo Compressor patch) into two
channels using only one effects processor. Using all four
effects processors will allow you to insert eight separate
compressors into eight individual channels at the same time.
The InsS option will allow you to turn the stereo four-band
parametric EQ patch into a mono eight-band parametric EQ
by inserting a single channel into one side of the stereo EQ
and then routing the signal through the other side of the
stereo EQ patch.
Snd (Insert Send Level)
This adjusts the level of signal (-42 dB to +6 dB) sent to the
effect. The default setting is 0 dB.
Rtn (Insert Return Level)
This adjusts the level of signal (-42 dB to +6 dB) returned
from the effect. The default setting is 0 dB.
6. Press [PLAY(DISPLAY)] to return to the Playlist display.
Use the above steps to insert EFX2-EFX 4.
Connecting Insert Effects in the
Master Block
It is possible to insert an effect into the MIX bus. For example,
you might want to send the entire song mix through a
compressor or limiter. Use the following steps to do so.
1. Press [EDIT/SOLO]. The button indicator lights, and the
Master screen appears in the display.
2. Use [
], [ ], [
cursor to "EfIns." Or, press [F1 (Ef1In)]. If "Ef1In" does
], and [ ] to move the
101