Roland VS-1680 User Manual page 134

Chapter 9 Automix
data to which you wish to apply the Gradation
operation.
7. Use [
] and [
marker of the Automix data to which you wish to apply
the Gradation operation, and press [F1 (In)].
8. Use [
] and [
marker of the Automix data to which you wish to apply
the Gradation operation, and press [F1 (Out)].
checkmarks will be added to the range selected for
Gradation.
fig.4-04.e
Check marks
You can turn the TIME/VALUE dial to modify the Automix
setting value at the cursor location. If you wish to re-select
the type of Automix data that will be edited, press [
9. Press [F4 (Grad)].
10. Use [
], [ ], [
cursor. Turn the TIME/VALUE dial to set each
parameter.
fig.4-16
Value
Adjust the beginning (In:) and end (Out:) of the Gradation
area.
Gradation Curve
Select the curve by which the gradation will be created.
Linear: Linear.
Exp+: Convex above (exponential curve).
Convex below (exponential curve).
Exp-:
134
] to move the cursor to the first
] to move the cursor to the last
], and [ ] to move the
fig.4-17
Linear
Marker Add
If this is turned on, markers will automatically be added to
the area specified for gradation in the optimal locations for
the curve that you selected in "Gradation Curve." If this is
turned off, markers will not be added.
fig.4-18.e
Gradation area
0 M1
11. To execute the Gradation operation, press [F4 (Exec)]. If
you press [F6 (EXIT)], you will return to Step 7 without
executing the Gradation operation.
12. A message will ask you to confirm the operation. Press
[YES]. If you press [NO], the Gradation operation will be
halted, and you will return to Step 11.
].
fig.4-19
13. When the Gradation operation has been executed, the
display will indicate "Complete." Press
[PLAY (DISPLAY)].
Increasing or Decreasing All Data
Values (Shift/Expand)
This operation increases or decreases the values of the
Automix data in a specific area. This can be done in two
ways:
Shift adds (or subtracts) the same amount to each Automix
data value.
Expand increases or decreases all Automix data values by
the same proportion relative to a specified standard value.
Exp+ Exp-
Gradation area
0 M1
M5
Time
M8
Time