Setting Up For Bouncing Using Step Editing - Roland VS-1680 User Manual

12. Select the Master Section settings. Use [
adjust each of the values.
fig.02-29
13. Press [F4 (Exec)]. "EZ ROUTING Step Edit is finished!!" appears in the display.
fig.02-24a
WARNING: EZ Routing settings will override any existing mixer settings you have already made.
14. You can save your setup as an EZ Routing template, or Exit [F6 (EXIT)] to leave this display without saving. To save the setup,
press [F3 (SAVE)]. The Routing Save screen appears in the display. Save the setup using the procedure described in "Saving an
EZ Routing Template," p. 121.

Setting Up for Bouncing Using Step Editing

Select this when bouncing audio recordings from a group of tracks onto another track or tracks. To cancel the settings procedure,
press [F6 (EXIT)].
1. Press [EZ ROUTING]. The EZ Routing icon appears in the display.
2. Press [F4 (Exec)]. If "Exec" does not appear in the display above [F4], press [PAGE] until you see "Exec," and then press [F4
(Exec)].
3. Press [F3 (Bounc)].
fig.02-18
], [ ], [
Monitor Select
Equalizer Mode
Direct Out
Effect Insert
], and [ ] to move the cursor and the TIME/VALUE dial to
Chapter 8 EZ Routing
115