HP ZBook 17 Service Manual page 98

6. Remove the four Torx T8M2.5x3.0 screws (1) that secure the clutch cover to the computer, and
then lift the cover from the computer (2).
NOTE:
7.
Remove the two Torx T8M2.5x7.0 screws that secure the display panel to the computer.
8.
Position the computer upright and open as far as possible.
CAUTION:
steps. Failure to support the display assembly can result in damage to the assembly and other
components.
9. Remove the two Torx T8M2.0x5.0 screws (1) that secure the display panel cable bracket to the
system board, and then lift the bracket off the system board (2).
10. Pull up on the display cable to disengage the adhesive that secures it to the base enclosure (3).
86 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
The clutch cover is available using spare part number 733634-001.
Support the display assembly when removing the display screws in the following