HP ZBook 17 Service Manual page 80

3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
Remove the display bezel:
1.
Position the computer upright and open it as far as possible.
2. Remove the screw covers (1) and the two Phillips PM2.0x7.0 screws (2) that secure the display
bezel to the display enclosure.
Screw covers are available in the Raw Panel Support Kit, spare part number 735590-001.
3. Flex the inside edges of the top edge (1), the left and right sides (2), and the bottom edge (3) of
the display bezel until the bezel disengages from the display enclosure and then remove the bezel
(4).
Reverse this procedure to install the display bezel.
68 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 46).