Adding A Printer (Mac Os X) - Xerox 4112 User Manual

Macintosh computers
8. Confirm the Install Location and change it if necessary, then click Install.
9. Click Quit.
This completes the installation.
Proceed to "Adding a Printer (Mac OS X)" to continue.

Adding a Printer (Mac OS X)

After the PPD file has been installed, set the PPD file for the printer driver and then add the
printer. The printer driver controls the printer functions based on the information in the PPD
file. Use the following procedure to add a printer. This procedure uses Macintosh OS X v10.2.8
as its example.
Note
Menu items and procedures may vary slightly for Mac OS X v10.3.3 or other operating system
versions.
1. Check that the port on the Xerox 4112/4127 Copier / Printer is set to Enable.
• When using AppleTalk, set the EtherTalk port to Enable.
• When using IP Printing, set the LPD port to Enable.
You can check the EtherTalk and LPD settings in the System Settings List. See the User
Guide for details about how to print the "System Settings List."
2. Start [Print Center].
Note
You can find Print Center in the Utilities folder in the Applications folder. For Mac OS X
10.3.3, open the Printer Setup Utility in the Utilities folder in the Applications folder.
The Printer List screen opens.
2-4
Xerox 4112/4127 Copier/Printer
PostScript User Guide