Fujitsu CT-10 User Manual page 24

SYSTEM TONES (Cont'd)
Internal Dial Tone
Key Tone
Override Tone
Recording Tone
Ringback Tone
Success Tone
Silent Message
Tone
This is a continuous tone that you hear when
you lift your handset. internal dial tone indicates
that you may:
0 Place an internal call (Intercom call).
o Request a special feature.
Key tone consists of three short bursts of tone
followed by a continuous dial tone. You hear
this tone after you press the TRANSFER button
or FLASH and before you dial a feature code.
Key tone indicates that you have correctly
accessed the system and can now proceed to
dial an extension number or a feature code.
You will also hear key tone when you place a
call if the Call Forward All Calls or Do Not
Disturb feature is activated.
Override tone is a series of tone bursts heard
when an extension with Executive Override
breaks into your call.
Recording tone is an extended burst of tone
indicating that an announcement is being
recorded from your extension.
Ringback tone is a standard ringing tone when
calling an idle telephone.
Success tone consists of four brief bursts of
tone heard after you request a specific feature.
Success tone indicates a feature has been
successfully implemented.
A brief burst of tone heard when a silent
message is left at your telephone. This tone is
not heard if the speakerphone is in use.
14