Hcs80/Css Operation; Hcs80/Css Stapling Hints; Unloading The Hcs80/Css Finishers - Xerox DocuColor 7002 User Manual

Optional Accessories

HCS80/CSS Operation

Some important tips to remember:
• The finishers cannot staple jobs with mixed sizes of paper.
• The stacking may be skewed on the output from mixed-size paper jobs.
• Only remove paper jams at the area indicated on the finisher Control Panel. Do not remove
paper from any other areas of the paper path.

HCS80/CSS Stapling Hints

There are three stapling options:
• Single Staple Position 1: The finishers place a staple in the upper left corner of Short Edge
Feed (SEF) or Long Edge Feed (LEF) sets.
• Single Staple Position 2: The finishers place a staple in the bottom left corner of SEF sets
only.
• Dual Staple: The finishers place two staples closer to the top/bottom center of the sheets
than a single staple.

Unloading the HCS80/CSS Finishers

To ensure consistent quality, unload sets of less than four sheets and lighter weight paper after
50 sets are made, or when the curl of the sets inhibits the ability of the sets to exit the finishers.
When the Stack Tray is full, Fault Code 112-550 appears in the message display on the finishers.
The digital press Touch Screen displays a message, "Unload the Main Tray of the Finisher."
The finishers continue to stack sheets into the Stack Tray after the message appears, but excess
sheets may have a degraded stacking quality. For best performance, unload the tray when
2,000 sheets have been stacked.
8-8
DocuColor 7002/8002
User Guide