Changing The Waste Dry Ink Bottle; Replacing A Corotron; When To Replace A Charge Corotron - Xerox DocuColor 7002 User Manual

DocuColor 7002/8002 Maintenance

Changing the Waste Dry Ink Bottle

Change the Waste Bottle when the "Change Waste Bottle" message is displayed on the UI.
Note
Refer to the video located on the Customer Documentation CD as needed.
The waste bottle is located inside a lower rear compartment of the Exit Module.
1. Open the Waste Bottle Door and pull the out the bottle.
2. Install the cap (found on the side of the bottle) and dispose of the bottle in accordance to
local regulations.
3. Install the new bottle and close the door.

Replacing a Corotron

When to replace a charge corotron

Unlike other consumable products for the digital press, a "replace corotron" message does not
display on the UI. You should replace a corotron unit only when an image quality problem
called banding, or rainbow banding, appear on prints. The Maintenance tab screen displays a
yellow triangle or a red circle when a pre-determined number of prints using a corotron unit
have been made. You should ignore these symbols and continue to use the corotron until
banding is seen on prints.
User Guide 9-9