Duplexing; Transparency Guidelines; Tabbed Inserts; Drilled Paper - Xerox DocuColor 7002 User Manual

Specifications

Duplexing

The system does not duplex media larger than 12.6 x 18 inch (321.1 x 458.1 mm).

Transparency Guidelines

Use only the transparencies recommended.
Transparencies can be run from all the paper trays.
• Xerox Removable Paper Stripe: USA and Canada, 3R5765; Xerox Europe, 3R93179.
• Load transparencies into a tray with the paper stripe side facing DOWN and with the stripe
as the leading edge. (The leading edge is the edge that feeds into the digital press first.)
• Do not mix paper and transparencies in a tray. Jams may occur.
• Ensure that Transparency is selected in the Paper Weight section at the top/front of the
paper tray.

Tabbed Inserts

Tabbed Inserts can be loaded into the paper trays as Non-Standard paper.
• When loading, the non-tabbed, short edge of the tabbed insert should be the lead edge to
the digital press.
• If a jam occurs while running tabbed sets, there is no recovery procedure.
• You have to manually reassemble your originals and prints, determine where the job left
off, and resume printing or cancel the job and start again.
• The size of the tabbed insert should be 9 x 11 inch (229 x 279 mm) for letter size tabs
(223.5 x 296 mm for A4 equivalent tabs).
• The correct weight of the insert should be selected on the tray.
• Select Non-Standard size on the paper tray and on the UI, Tools Mode, input 11 inches or
296 mm for A4 as the X axis and 9 inches or 223.5 mm for A4 as the Y axis dimensions for
SEF.
Note
Refer to the System Administration Guide for the procedure to program non-standard size
paper.

Drilled Paper

Three-hole drilled paper can be run from all the trays either LEF or SEF with the holes facing any
direction.
Note
If you are stapling 3-hole drilled paper with the optional High Capacity Stacker Stapler 80
(HCSS80), refer to the Accessories chapter for paper loading instructions, based on the position
of the staple.
Drilled paper should be run in the Simplex (1-sided) and Duplex (2-sided) orientations shown
below to avoid paper jams caused by the holes not aligning correctly with the paper sensor in
the press.
11-2
DocuColor 7002/8002
User Guide