Lan Connection; Refresh; Chapter 5: Ip Camera Web Manager; Section 1. Introduction - Security Labs PTZ IP Camera User Manual

ii. Management Protocol
The administrator can determine the parameter settings when providing access via
HTTP (web) to IP Camera. For security reasons, the administrator can choose to
use either an open or advanced port setting to control this access. The default
values are set to port number 80 for HTTP. Once the HTTP port number is set to
another port (other than 80), the full IP Address must be entered in order to access
the Website.
For example:
If a value of 61 is set as the HTTP port number, then
must be entered as the web address in order to access the camera.
Uncheck to disable this function.
Device Password not set.
Device Password enabled. IP Address hidden.

2.5 LAN Connection

To switch to another Network Adaptor, click on "LAN Connection".

2.6 Refresh

IP Camera Utility
the LAN. However, you can do a manual search by click the "Refresh" icon located
at the bottom right of the menu.

Chapter 5: IP Camera Web Manager

Section 1. Introduction

After you have setup the hardware and set an IP address for the IP Camera, you will then
be able to go to the IP Camera web site to monitor and control the camera(s). All you
have to do is enter the new IP address into any compatible web browser.
1. Start the Web Brower (Netscape or Internet Explorer)
IP Camera Manual
Fig.13 Netility version examined
automatically searches
http://192.168.0.177:61
for any IP Camera connected to
17