Automatic Calendar Setting - Siemens SPCK620 User Manual

Multi area view
6

Automatic Calendar Setting

6.5
22
Siemens AB
Security Products
2. Press .
3. Scroll using the ▲ ▼ keys until the required area is visible.
4. Press the softkey below the blinking fault symbol.
NOTICE
There is a fixed soft key assignment to set / partset / unset areas or area groups.
Due to this the location of the fault icon can vary. In the above picture, there is a
fault in unset condition.
5. In the next screen, the fault(s) will be listed.
There are 2 fault symbols possible:
Fault can not be restored. Fault condition still present. Please contact your installer.
!
!
!
Fault can be restored.
If the fault can be restored, press the softkey below the symbol

 The fault is restored.
 Ready will be shown on the display.
Automatic Calendar Setting
A calendar may be assigned to an area to control setting and unsetting. When an
area is unset, you will hear an audible beep from the keypad. A warning time is
.
A6V10271018
26.09.2011