6.4
Siemens AB
Security Products
There are 2 alarm symbols possible:
Alarm can not be restored. Alarm condition still present (e.g. the zone which
!
!
caused the alarm is still open). Please contact your installer if symbol is still
indicated after closing according zone (e.g. window).
Alarm can be restored.
If the alarm can be restored, press the key
The alarm is restored.
Resetting a fault
If there is any fault, this will be displayed after login.
!
The symbol
!
The LED
is blinking.
NOTICE
In the below pictures a system wide fault (e.g. X-Bus cable fault) is indicated. Due
to this the fault symbol is displayed behind all area groups / areas. It is sufficient
to restore the fault once. In this case it does not matter which area group / area is
selected.
1. Scroll using the ▲ ▼ keys until the required area group is visible.
is blinking.
Multi area view
Resetting a fault
.
A6V10271018
26.09.2011
6
21