User Programming Via The Keypad; Setting And Unsetting The System - Siemens SPCK 420 User Manual

User programming via the keypad

6

Setting and unsetting the system

6 User programming via the keypad
6.1
14
Siemens AB
Security Products
User programming options are available using the LCD and Comfort Keypads.
Menus and options available on the intrusion control panel is programmed by the
installation engineer. If users cannot see an option described in this manual, they
do not have rights to access that functionality.
To access user programming:
1. Enter a valid User PIN.
2. Using the up/down arrow keys, scroll to the desired programming option.
3. Within a menu option, press # to select or enable/disable a parameter (for
example, a user right). The selected parameter is displayed with an * (for
example, *Inhibit).
 The keypad displays UPDATED momentarily to indicate a parameter change.
An alternative method of selecting menu options is to enter the user PIN and the
number of the menu option as shown in the graphic above. Options 1 to 4 enable
you to set and unset the system. 0 selects the user MENUS. To select an option
within MENUS, enter the PIN and 0, and then select the required menu number.
Setting and unsetting the system
For each menu option, the keypad must be in User programming:
1. Enter a valid User code.
2. To select a programming option, use the up/down arrow keys or enter the digit
listed in the table below.
A6V10209178
26.09.2011