Viewing Mode Description - Siemens SPCK620 User Manual

3.2
Siemens AB
Security Products
Amber
User Green
Alarm
Alert Amber
!
Mains Green
NOTICE
The LED indications for information, area status, alarm and fault is deactivated in
idle state of the keypad. A valid user PIN has to be entered. It is configurable if
the power indication can be seen in idle state.

Viewing mode description

There are 2 viewing modes (automatic):
Multi area view: User has access to several areas. Displaying the areas is done

via area groups. If no area group is configured, only the general group "All my
areas" is displayed.
Single area view: The user has only rights for 1 area. In the single area view,

only one area is displayed in large fonts and can be controlled directly.
NOTICE
The rights of a user can be restricted by the user settings or the settings of the
keypad the user is logging in to. Only if the user and the keypad that is being
used for logging in have the right for an area, the area is displayed. If the user has
the right for several areas but the keypad has only the right for one area, the user
will also see the single area view.
Flashing Engineer is on site.
On Assigned area is unset.
Flashing Assigned area is Partset A / B
Off Assigned area is fullset
Red On Alarm
Flashing -
Off No alarm
On -
Flashing Trouble
Off No trouble
On System ok
Flashing Mains fault
Off No bus connection
Introduction
Viewing mode description
A6V10271018
26.09.2011
3
11