Configuring Advanced Internet Connection - ZyXEL Communications P-662H-61 User Manual

Table 21 Internet Connection
LABEL
Password
Service Name
Multiplexing
Virtual Circuit ID
VPI
VCI
IP Address
Obtain an IP
Address
Automatically
Static IP Address
IP Address
Subnet Mask
Gateway IP address (ENET ENCAP only) Enter the gateway IP address provided by your ISP.
Connection
Nailed-Up
Connection
Connect on
Demand
Max Idle Timeout
Apply
Cancel
Advanced Setup

5.5.1 Configuring Advanced Internet Connection

Use this screen to edit your ZyXEL Device's advanced WAN settings. Click the Advanced
Setup button in the Internet Connection screen. The screen appears as shown.
P-662H/HW-D Series User's Guide
DESCRIPTION
(PPPoA and PPPoE only) Enter the password associated with the user name
above.
(PPPoE only) Type the name of your PPPoE service here.
Select the method of multiplexing used by your ISP from the drop-down list.
Choices are VC or LLC.
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual
circuit. Refer to the appendix for more information.
The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.
The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local
management of ATM traffic). Enter the VCI assigned to you.
These fields only appear if the Mode is Routing.
A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is
not fixed; the ISP assigns you a different one each time you connect to the
Internet. '
(PPPoE, PPPoA, and ENET ENCAP only) Select this if you have a dynamic IP
address.
(PPPoE, PPPoA, and ENET ENCAP only) Select this if you do not have a
dynamic IP address.
Enter the static IP address provided by your ISP.
(ENET ENCAP only) Enter the subnet mask provided by your ISP.
This section only appears if the Encapsulation is PPPoE and PPPoA.
Select Nailed-Up Connection when you want your connection up all the time.
The ZyXEL Device will try to bring up the connection automatically if it is
disconnected.
Select Connect on Demand when you don't want the connection up all the time
and specify an idle time-out in the Max Idle Timeout field.
Specify an idle time-out in the Max Idle Timeout field when you select Connect
on Demand. The default setting is 0, which means the Internet session will not
timeout.
Click Apply to save the changes.
Click Cancel to begin configuring this screen afresh.
Click this button to display the Advanced WAN Setup screen and edit more
details of your WAN setup.
Chapter 5 WAN Setup
87